Free Craft Pattern from Lion Brand Yarn, formatted for input to refreshable Braille displays or Braille software
Loop Fringe for a Scarf
Lion Brand® Velvetspun
Pattern Number: BK4K-0602004
This pattern shows how to add a loop fringe to decorate and customize a purchased scarf.

SKILL LEVEL:  Beginner (Level 1)
SIZE: One Size
Depends on scarf; fringe shown is approximately 8 inches. [20 cm]

PUBLISHED IN: By Kids, For Kids


CORRECTIONS: None

MATERIALS

580-101 Velvetspun Yarn: Carnation Gentle soft pink
Quantity needed: 1 Skeins
Estimated Price: $ 3.00
Note: Any yarn can be used that matches your scarf
Additional Materials
Purchased scarf Size 1 [2.5mm] crochet hook or size needed to pull yarn through the scarf
NOTES:
Gauge is not important to this project; length of fringe should be as it appeals to you.


INSTRUCTIONS



FRINGE
There are many kinds of fringe.

Some yarns do well with a fringe that has loose ends, but some unravel.

In this case, a loop fringe is a good choice because there are no free ends to come apart.




Lay the scarf flat on the table, right side up with the edge facing you.

Insert the hook from the bottom to the top approximately 1/2 inch [.5 cm] from the end and side of the scarf and pull the end of the yarn down so that it is underneath the scarf.

This is the end that you will need to tie off.



1.

Insert the hook from the top to the bottom of the scarf approximately 1/2 inch from then end but approximately 1/4 inch [1 cm] from last loop (or the side, if this is the first loop or very last loop on the fringe.)
2.

Pull a loop of yarn through from the bottom to the top of the scarf
3.

Put your finger through the loop and pull a second loop through the first one.



On the first loop only, use the free end that is under the bottom of the scarf and tie it securely to the end that is coming up.

Use several knots and trim the yarn.



4.

The strand of yarn that is on the left can be pulled to tighten the first loop.

Pull this tight.


5.

Pull on the free end of the yarn (the end that goes to the ball) so that the loop is the length you want.

As shown in the picture, loops will normally twist -- this is expected.



Repeat steps 1-5 until the end is completely fringed.


Cut the end of the yarn to approximately 5 inches and tie off tightly to one of the strands of the last loop.

Tie several knots to be sure that the yarn will not unravel or come loose.

Trim closely.

ABBREVIATIONS / REFERENCES
ch(s) = chain(s)
hdc = half double crochet
rep = repeat(s)(ing)
rnd(s) = round(s)
RS = right side
sc = single crochet
sl st = slip stitch
st(s) = stitch(es)
beg = begin(s)(ning)
k = knit
k2tog = knit 2 together
rnd(s) = round(s)
RS = right side
St st = Stockinette stitch
st(s) = stitch(es)
WS = wrong side


Every effort has been made to have the knitting and crochet instructions accurate and complete. We cannot be responsible for variance of individual knitters and crocheters, human errors, or typographical mistakes.
We want your project to be a success! If you need help with this or any other Lion Brand pattern, e-mail support is available 7 days per week by mailing support@lionbrand.com.

For over a thousand free patterns available in versions for the vision-impaired, visit our website http://www.LionBrand.com

To order, visit our website http://www.e-yarn.com or call: (800) 258-9276 any time!

Copyright ©1998-2011 Lion Brand Yarn Company, all rights reserved. No pattern or other material may be reproduced -- mechanically, electronically, or by any other means, including photocopying -- without written permission of Lion Brand Yarn Company.

Click here for Non-Braille display: View With Images